Tiling a Floor
Flooring, Interior by Danny Lipford
While ceramic tile can be applied directly to a concrete slab, wooden floors should be covered with cement backer board first. On areas that are not easily seen, start with whole tiles along one the edge. For more visible areas, mark the midpoints of each wall, and pop a chalk line on the floor in both directions. Use the point where the two lines cross as the center for laying out your tile.
- Mix thin-set mortar with water and apply with a notched trowel.
- Cut the border tiles to width with a scoring cutter or wet saw.
- Press the tiles into the adhesive, and check to be sure they are level.
- Use plastic spacers to keep grout lines uniform.
- Allow the mortar to set overnight then apply grout in the cracks with a rubber float.
- When the grout starts to set, clean off any excess with a wet sponge.
- Rinse the sponge in a bucket of water and go over the floor until any remaining grout haze has been removed from the tile.
- After the grout has cured for the recommended time, apply a sealer in high traffic areas to keep it from staining.
October 6th, 2007 at 3:44 pm
I live in Indianapolis, Indiana. I have a screened in patio. I want to apply some tile to the floor. Is there a specific tile or adhesive that is required for cold temperatures.
Thank you very much
October 7th, 2007 at 8:09 am
Show how to remove garbage disposal and the plumbing necessary to the drain pipe.
November 3rd, 2007 at 7:44 pm
which is better for a kitchen. linoleum of good quality, or tile…i have mixed thoughts as to which is better. the cost is of no cosequence. i just want a good floor.
November 20th, 2007 at 5:25 pm
I am getting ready to install this new Trafficmaster Allure Vinyl plank flooring in my master bath. At the present time it has a wood subfloor with a berber tight weave carpet on top of it. One of the guys at Home Depot said that I could actually install this vinyl flooring on top of the carpeting and use it for a cushion. What is your feelings on this one? I think it would be nice if it won’t mess up the vinyl flooring. The carpet is in very good shape and has no tears in it at all. Please advise!
John Gonzales
December 5th, 2007 at 5:24 pm
I am going to put new flooring in my bathroom. What is better linoleum or ceranmic tile? Rite now i have linoleum and it is start to peel at the corners and starting to crack. I have a very small bathroom. Please advice!!!
thank you, cheryl
December 11th, 2007 at 2:48 am
We just were flooded in our downstairs basement. We removed the carpet and the pad is indoor/outdoor carpeting. When removed it has left the black foam that is attached to the concrete floor. We are scraping up the foam and want to know what would be the best choice for the 2 bedroom, hallway and living area (all concrete)….tiling or an acid stain. The chances of minor flooding could happen in the future. What would be your advice?
Thank you,
August 13th, 2008 at 11:19 am
You say to seal the grout when it has cured, mine was not when it was installed and now I want to, after I throughly clean it I need to know what to seal it with, I have heard that polyurethane varnish is good, or do I have to buy a special sealer? thanks,
Reggie