Using CFLs in Light Fixtures

Ask Danny, Electrical and Lighting, Green Living by Danny Lipford

My light fixtures have a maximum rating for wattage bulbs (i.e. 60 watt, etc.). If I change to the energy efficient bulbs (screw in fluorescent) do the recommended wattage ratings still apply? I thought that the wattage rating has to do with the amount of heat that the bulb generated thus creating a fire hazard. The fluorescent bulbs do not generate as much heat as the incandescent bulbs so can I go up on the bulb wattage? The same wattage fluorescent bulbs seem dimmer than the incandescent bulbs. - Thanks Ricky

Hi Ricky,

Yes, you can use a compact fluorescent (CFL) bulb that produces more light as long as it doesn’t exceed the wattage recommended for the fixture.

Light bulbs are commonly compared using both watts and lumens. Watts are the amount of electricity used by the bulb while lumens measure the light produced. Light fixtures have a maximum wattage rating to prevent the wiring and area around the fixture from overheating and causing a fire. Since CFLs uses a fourth the electricity of a comparably bright incandescent, they produce far less heat. So you can use a compact fluorescent bulb that gives more light (lumens) than an incandescent as long as it doesn’t consume more electricity (watts) than the fixture recommends.

To give an example, say your light fixture calls for a maximum of 60 watts. A CFL bulb that produces the same amount of light as a 60 watt incandescent bulb (900 lumens) only uses around 15 watts of electricity. So you can put a CFL in the fixture that equals the light output of a 100 watt incandescent (1,600 lumens) and still only use 25 watts of electricity.

When comparing the light output of the two types of bulbs, remember that it takes CFLs a few minutes to reach their peak light output. More information on compact fluorescent light bulbs can be found in our article CFL: A Bright Idea for Going Green.

You can follow any responses to this entry by subscribing to the news feed with your favorite feed reader. You can leave a comment by skipping to the end of the page. You can trackback to this article from your own site.

2 Responses to “Using CFLs in Light Fixtures”

  1. Mark Says:
    March 10th, 2008 at 9:51 pm

    It’s true the CFL only uses 15 watts, however you are paying for 25 VA of electricity. In other words you are not getting your moneys worth. These CFL bulbs have a very high power factor, and requires more electricity to run the transformers inslde the bulb that it can product.

    Also it is recommended that you call HazMet if you break one of these new fangled, over priced piecs of junk.

    The ‘Old’ Incandescent you got what you paid for 100 watts is exactly what you get. Not so with this scam of the CFL.

  2. Phil Says:
    September 25th, 2008 at 8:33 am

    Sorry Mark, but that’s complete rubbish.

Leave a Comment